Hi Pragnesh, On Mon, May 25, 2020 at 3:33 PM Pragnesh Patel <[email protected]> wrote: > > This series add support for SPL to FU540. U-Boot SPL can boot from > L2 LIM (0x0800_0000) and jump to OpenSBI(FW_DYNAMIC firmware) and > U-Boot proper from MMC devices. > > This series is also available here [1] for testing > [1] https://github.com/pragnesh26992/u-boot/tree/spl > > How to test this patch: > 1) Go to OpenSBI-dir : make PLATFORM=generic FW_DYNAMIC=y > 2) export OPENSBI=<path to > opensbi/build/platform/generic/firmware/fw_dynamic.bin> > 3) Change to u-boot-dir > 4) make sifive_fu540_defconfig > 5) make all > 6) Format the SD card (make sure the disk has GPT, otherwise use gdisk to > switch) > > # sudo sgdisk --clear \ > > --set-alignment=2 \ > > --new=1:34:2081 --change-name=1:loader1 > --typecode=1:5B193300-FC78-40CD-8002-E86C45580B47 \ > > --new=2:2082:10273 --change-name=2:loader2 > --typecode=2:2E54B353-1271-4842-806F-E436D6AF6985 \ > > --new=3:10274: --change-name=3:rootfs > --typecode=3:0FC63DAF-8483-4772-8E79-3D69D8477DE4 \ > > /dev/sda > > 7) sudo dd if=spl/u-boot-spl.bin of=/dev/sda seek=34 > 8) sudo dd if=u-boot.itb of=/dev/sda seek=2082 > > Changes in v12: > - Rebase on mainline U-Boot > Added necessary include files which are not part of common header now > Remove unnecessary include files > > drivers/misc/sifive-otp.c > +#include <linux/bitops.h> > +#include <linux/delay.h> > > board/sifive/fu540/fu540.c > -#include <common.h> > +#include <log.h> > > board/sifive/fu540/spl.c > +#include <init.h> > +#include <log.h> > +#include <linux/delay.h> > > drivers/ram/sifive/fu540_ddr.c > +#include <linux/bitops.h> > > arch/riscv/cpu/fu540/cpu.c > -#include <common.h> > +#include <asm/cache.h> > > arch/riscv/cpu/fu540/spl.c > -#include <common.h> > +#include <log.h> > > board/sifive/fu540/spl.c > -#include <common.h> > +#include <init.h> > +#include <log.h> > +#include <linux/delay.h> > > - Update commit description for Release ethernet clock reset > - Update OpenSBI building section in "doc/board/sifive/fu540.rst" >
Thanks. During the testing I found there is one issue about ethernet. The 1000Mbps does not work. Only 100Mbps works. Could you please have a look? Regards, Bin
