CONFIG_ENV_SIZE only needs page alignment, not block Document CONFIG_ENV_RANGE and CONFIG_ENV_OFFSET_OOB.
Signed-off-by: Scott Wood <[email protected]> --- README | 22 +++++++++++++++++++--- 1 files changed, 19 insertions(+), 3 deletions(-) diff --git a/README b/README index aa11c37..4d95a8b 100644 --- a/README +++ b/README @@ -2551,16 +2551,32 @@ to save the current settings. These two #defines specify the offset and size of the environment area within the first NAND device. - - CONFIG_ENV_OFFSET_REDUND + - CONFIG_ENV_OFFSET_REDUND (optional): This setting describes a second storage area of CONFIG_ENV_SIZE size used to hold a redundant copy of the environment data, so that there is a valid backup copy in case there is a power failure during a "saveenv" operation. + - CONFIG_ENV_RANGE (optional): + + Specifies the length of the region in which the environment + can be written. This should be a multiple of the NAND device's + block size. Specifying a range with more erase blocks than + are needed to hold CONFIG_ENV_SIZE allows bad blocks within + the range to be avoided. + + - CONFIG_ENV_OFFSET_OOB (optional): + + Enables support for dynamically retrieving the offset of the + environment from block zero's out-of-band data. The + "nand env.oob" command can be used to record this offset. + Currently, CONFIG_ENV_OFFSET_REDUND is not supported when + using CONFIG_ENV_OFFSET_OOB. + Note: CONFIG_ENV_OFFSET and CONFIG_ENV_OFFSET_REDUND must be aligned - to a block boundary, and CONFIG_ENV_SIZE must be a multiple of - the NAND devices block size. + to an erase block boundary, and CONFIG_ENV_SIZE must be a multiple + of the NAND device's page size. - CONFIG_NAND_ENV_DST -- 1.7.0.4 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
