Hi Mauro,
On 01.09.20 15:09, Mauro Condarelli wrote:
<snip>
Now problem is "Unable to allocate 209398 bytes for LZMA"
Full trace below.
I assume I should enlarge
#define CONFIG_SYS_MALLOC_LEN (1024 * 1024)
since GARDENA has:
#define CONFIG_SYS_MALLOC_LEN (16 * 1024 * 1024)
but I would like a confirmation, if possible.
Its the SPL malloc area, so you need to change a different value:
Please try to increase this value via Kconfig:
CONFIG_SPL_SYS_MALLOC_F_LEN
On GARNEDA its currently this:
CONFIG_SPL_SYS_MALLOC_F_LEN=0x40000
HTH,
Stefan
TiA!
full trace: =============================
U-Boot SPL 2020.04-rc1 (Mar 29 2020 - 17:07:13 +0200)
Trying to boot from NOR
U-Boot 2020.04-rc1 (Mar 29 2020 - 17:07:13 +0200)
CPU: MediaTek MT7628A ver:1 eco:2
Boot: DDR2, SPI-NOR 3-Byte Addr, CPU clock from XTAL
Clock: CPU: 580MHz, Bus: 193MHz, XTAL: 40MHz
DRAM: 128 MiB
WDT: Started with servicing (60s timeout)
MMC: mmc@10130000: 0
Loading Environment from SPI Flash... SF: Detected w25q128 with page size 256
Bytes, erase size 4 KiB, total 16 MiB
OK
In: uart2@e00
Out: uart2@e00
Err: uart2@e00
Model: VoCore2
Net:
Warning: eth@10110000 (eth0) using random MAC address - 8a:c1:c1:2a:28:91
eth0: eth@10110000
Hit any key to stop autoboot: 0 <--- booting ok
with "mtmips"
=> ls mmc 0:1
179840 uboot-ram_20170210.bin
179840 uboot-ram.bin
183272 uboot-rom_20170213.bin
183272 uboot-rom_20170423.bin
1819846 uImage.initram
1473392 initram.cpio.xz
1819846 uImage
534530 u-boot.bin
12713984 recov.squashfs
52983808 okcash.swu
698880 persist_data.tar
97 net.cfg
2360074 recov.uImage-old
247721 u-boot-with-spl.bin
244580 u-boot-mtmips.bin
15 file(s), 0 dir(s)
=> load mmc 0:1 80200000 u-boot.bin
534530 bytes read in 35 ms (14.6 MiB/s)
=> go ${fileaddr} <---
test of raw image (OK)
## Starting application at 0x80200000 ...
U-Boot 2020.10-rc3-00012-g9f04a634ef-dirty (Sep 01 2020 - 09:40:13 +0200)
CPU: MediaTek MT7628A ver:1 eco:2
Boot: DDR2, SPI-NOR 3-Byte Addr, CPU clock from XTAL
Clock: CPU: 580MHz, Bus: 193MHz, XTAL: 40MHz
DRAM: 128 MiB
WDT: Started with servicing (60s timeout)
MMC: mmc@10130000: 0
Loading Environment from SPIFlash... SF: Detected w25q128 with page size 256
Bytes, erase size 4 KiB, total 16 MiB
OK
In: uart2@e00
Out: uart2@e00
Err: uart2@e00
Model: VoCore2
Net:
Warning: eth@10110000 (eth0) using random MAC address - 7e:fc:d1:78:a2:4e
eth0: eth@10110000
Hit any key to stop autoboot: 0
=> sf probe
=> load mmc 0:1 85000000 u-boot-with-spl.bin <--- use raw image to reflash
247721 bytes read in 18 ms (13.1 MiB/s)
=> sf update ${fileaddr} 0 ${filesize}
device 0 offset 0x0, size 0x3c7a9
247721 bytes written, 0 bytes skipped in 2.269s, speed 111648 B/s <---
apparently OK
=> reset
resetting ...
U-Boot SPL 2020.10-rc3-00012-g9f04a634ef-dirty (Sep 01 2020 - 09:40:13 +0200)
Trying to boot from NOR
alloc space exhausted
Unable to allocate 209398 bytes for LZMA
SPL: failed to boot from all boot devices
### ERROR ### Please RESET the board ###
*** DTR: up ***
<--- this is effectively a power-cycle
*** DTR: down ***
U-Boot SPL 2020.10-rc3-00012-g9f04a634ef-dirty (Sep 01 2020 - 09:40:13 +0200)
Trying to boot from NOR
alloc space exhausted
Unable to allocate 209398 bytes for LZMA <--- same error
SPL: failed to boot from all boot devices
### ERROR ### Please RESET the board ###
*** DTR: up ***
Viele Grüße,
Stefan
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-51 Fax: (+49)-8142-66989-80 Email: [email protected]
