Hi, On 15. 09. 20 16:45, Sean Anderson wrote: > Use `bus` instead of `dev`. > > Signed-off-by: Sean Anderson <[email protected]> > --- > > Changes in v2: > - New > > drivers/spi/zynqmp_gqspi.c | 6 +++--- > 1 file changed, 3 insertions(+), 3 deletions(-) > > diff --git a/drivers/spi/zynqmp_gqspi.c b/drivers/spi/zynqmp_gqspi.c > index a72986be90..e0e6687037 100644 > --- a/drivers/spi/zynqmp_gqspi.c > +++ b/drivers/spi/zynqmp_gqspi.c > @@ -346,20 +346,20 @@ static int zynqmp_qspi_probe(struct udevice *bus) > > ret = clk_get_by_index(bus, 0, &clk); > if (ret < 0) { > - dev_err(dev, "failed to get clock\n"); > + dev_err(bus, "failed to get clock\n"); > return ret; > } > > clock = clk_get_rate(&clk); > if (IS_ERR_VALUE(clock)) { > - dev_err(dev, "failed to get rate\n"); > + dev_err(bus, "failed to get rate\n"); > return clock; > } > debug("%s: CLK %ld\n", __func__, clock); > > ret = clk_enable(&clk); > if (ret && ret != -ENOSYS) { > - dev_err(dev, "failed to enable clock\n"); > + dev_err(bus, "failed to enable clock\n"); > return ret; > } > plat->frequency = clock; >
Good catch. Reviewed-by: Michal Simek <[email protected]> Thanks, Michal
