On 2/1/21 12:37 PM, Fabio Estevam wrote:
Hi Marek,
Hello Fabio,
On Mon, Feb 1, 2021 at 8:28 AM Marek Vasut <ma...@denx.de> wrote:
Did you test that yourself? I am CCing Christoph, as I don't have the
Yes, I tested it myself:
U-Boot SPL 2021.01 (Jan 23 2021 - 14:34:35 -0300)
Trying to boot from MMC1
U-Boot 2021.01 (Jan 23 2021 - 14:34:35 -0300)
CPU: Freescale i.MX6Q rev1.2 996 MHz (running at 792 MHz)
CPU: Automotive temperature grade (-40C to 125C) at 43C
Reset cause: POR
Model: Freescale i.MX6 Quad SABRE Smart Device Board
I2C: ready
DRAM: 1 GiB
PMIC: PFUZE100 ID=0x10
MMC: FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 3
Loading Environment from MMC... OK
No panel detected: default to Hannstar-XGA
Display: Hannstar-XGA (1024x768)
In: serial
Out: serial
Err: serial
Net: eth0: ethernet@2188000
Hit any key to stop autoboot: 0
board. The report I am getting is that it does not boot fine on his end
when writing u-boot-with-spl.imx to SD card at offset 1024B.
I have flashed the SD card by writing SPL at offset 1kB and
u-boot-dtb.img at 69kB.
Then I have to wonder, does it also work if you write
u-boot-with-spl.imx to the SD card ? If not, then that might be the
problem .
