Since set_control_reg is available in sdhci.c, use it and remove
arasan_sdhci_set_control_reg().
Signed-off-by: Ashok Reddy Soma <ashok.reddy.s...@xilinx.com>
Reviewed-by: Jaehoon Chung <jh80.ch...@samsung.com>
---
(no changes since v1)
drivers/mmc/zynq_sdhci.c | 21 +--------------------
1 file changed, 1 insertion(+), 20 deletions(-)
diff --git a/drivers/mmc/zynq_sdhci.c b/drivers/mmc/zynq_sdhci.c
index 89776f48eb..73bb3abbc2 100644
--- a/drivers/mmc/zynq_sdhci.c
+++ b/drivers/mmc/zynq_sdhci.c
@@ -690,29 +690,10 @@ static void arasan_dt_parse_clk_phases(struct udevice
*dev)
"clk-phase-mmc-hs400");
}
-static void arasan_sdhci_set_control_reg(struct sdhci_host *host)
-{
- struct mmc *mmc = (struct mmc *)host->mmc;
- u32 reg;
-
- if (!IS_SD(mmc))
- return;
-
- if (mmc->signal_voltage == MMC_SIGNAL_VOLTAGE_180) {
- reg = sdhci_readw(host, SDHCI_HOST_CONTROL2);
- reg |= SDHCI_CTRL_VDD_180;
- sdhci_writew(host, reg, SDHCI_HOST_CONTROL2);
- }
-
- if (mmc->selected_mode > SD_HS &&
- mmc->selected_mode <= MMC_HS_200)
- sdhci_set_uhs_timing(host);
-}
-
static const struct sdhci_ops arasan_ops = {
.platform_execute_tuning = &arasan_sdhci_execute_tuning,
.set_delay = &arasan_sdhci_set_tapdelay,
- .set_control_reg = &arasan_sdhci_set_control_reg,
+ .set_control_reg = &sdhci_set_control_reg,
};
#endif
--
2.17.1
