Am Fri, Sep 03, 2021 at 08:25:39PM +0200 schrieb Heiko Thiery: > Hi Patrick, > > Am Fr., 3. Sept. 2021 um 16:30 Uhr schrieb Patrick Wildt <patr...@blueri.se>: > > > > Am Fri, Sep 03, 2021 at 11:01:06AM +0200 schrieb Heiko Thiery: > > > Hi Patrick, > > > > > > Am Do., 2. Sept. 2021 um 23:44 Uhr schrieb Patrick Wildt > > > <patr...@blueri.se>: > > > > > > > > The MNT Reform 2 is a modular DIY laptop. In its initial version it > > > > is based on the BoundaryDevices i.MX8MQ SoM. Some parts have been > > > > lifted from BoundaryDevices official U-Boot downstream project. > > > > > > > > Signed-off-by: Patrick Wildt <patr...@blueri.se> > > > > > > I just sent a patch to add board support for the Kontron pitx-imx8m > > > that is also based on the imx8mq SOC. I already switched the flash.bin > > > generation to binman. Maybe you can use this patchset as a template > > > and also switch to binman for that board. > > > > > > -- > > > Heiko > > > > Hi Heiko, > > > > I think that's a good idea. But I seem to be having issues: > > > > U-Boot SPL 2021.10-rc3-00023-g2c634e01b6-dirty (Sep 03 2021 - 18:22:04 > > +0200) > > Normal Boot > > Could not get FIT buffer of 686592 bytes > > check CONFIG_SYS_SPL_MALLOC_SIZE > > I'm not sure, but could you check that no old fragments are left in > the output folder before building the flash.bin with binman. I can > remember that I had also some strange issues while switching to > binman.
No change. Is your u-boot.itb that much smaller? -rw-r--r-- 1 patrick patrick 670K Sep 4 00:50 imx8mq_reform2/u-boot.itb
