Hello,
I wasn't quite sure where to report this, so I figured I would start
with the mailing list. If there is another place I should go, please
feel free to redirect me.
I'm a user if IPFire which uses u-boot. I recently bought a new
Raspberry Pi 4b 4gb device, but it fails to boot with a loop that says:
|invalid bus width error -22 whilst initialising SD Card |I originally opened up a bug report with the IPFire team (https://bugzilla.ipfire.org/show_bug.cgi?id=12690), but it now appears that this is a|but somewhere in u-boot. I downloaded an Ubuntu 20.04 image that
behaves the same way. As I stated in the IPFire issue, I'm seeing this
behavior on a Raspberry Pi, but not on an older device. I ran a number
of tests:|
To validate that this is an issue with newer hardware, I was able to take
advantage of another Pi 4 that is probably a year or so old in my Retropie
setup. I used that Pi and a Samsung 32G EVO SD card. I tried the following
combinations, all with a monitor and keyboard attached (and SERIAL set to off
in uEnv.txt):
* RaspiOS - "old" Pi 4 - Works
* RaspiOS - "new" Pi 4 - Works
* IPFire - "old" Pi 4 - Works
* IPFire - "new" Pi 4 - Boot loops
As discussed in the forum thread, this looks suspiciously like an issue with
U-Boot on newer Pi 4 hardware as discussed here:
*https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=255080
<https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=255080>
*https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=255080#c47
<https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=255080#c47>
Craig
||
