On Thu, Sep 30, 2021 at 7:53 AM <tkuw584...@gmail.com> wrote:
>
> From: Takahiro Kuwano <takahiro.kuw...@infineon.com>
>
> The S25FL256L is a part of the S25FL-L family and has the same feature set
> as S25FL128L except the density.
>
> The datasheet can be found in the following link.
> https://www.cypress.com/file/316171/download
>
> The S25FL256L is 32MB NOR Flash that does not support Bank Address
> Register. This fixup is activated if CONFIG_SPI_FLASH_BAR is enabled and
> returns ENOTSUPP in setup() hook to avoid further ops.
>
> Tested on Xilinx Zynq-7000 FPGA board.
>
> Signed-off-by: Takahiro Kuwano <takahiro.kuw...@infineon.com>
> ---
> Changes in v2:
>   - Merge separated patches into one
>   - Remove #ifdef CONFIG_SPI_FLASH_BAR
>
>  drivers/mtd/spi/spi-nor-core.c | 19 +++++++++++++++++++
>  drivers/mtd/spi/spi-nor-ids.c  |  1 +
>  2 files changed, 20 insertions(+)
>
> diff --git a/drivers/mtd/spi/spi-nor-core.c b/drivers/mtd/spi/spi-nor-core.c
> index f1b4e5ea8e..7572be5e34 100644
> --- a/drivers/mtd/spi/spi-nor-core.c
> +++ b/drivers/mtd/spi/spi-nor-core.c
> @@ -3224,6 +3224,21 @@ static struct spi_nor_fixups s25hx_t_fixups = {
>         .post_bfpt = s25hx_t_post_bfpt_fixup,
>         .post_sfdp = s25hx_t_post_sfdp_fixup,
>  };
> +
> +static int s25fl256l_setup(struct spi_nor *nor, const struct flash_info 
> *info,
> +                          const struct spi_nor_flash_parameter *params)
> +{
> +       return -ENOTSUPP; /* Bank Address Register is not supported */
> +}
> +
> +static void s25fl256l_default_init(struct spi_nor *nor)
> +{
> +       nor->setup = s25fl256l_setup;
> +}
> +
> +static struct spi_nor_fixups s25fl256l_fixups = {
> +       .default_init = s25fl256l_default_init,
> +};
>  #endif
>
>  #ifdef CONFIG_SPI_FLASH_S28HS512T
> @@ -3646,6 +3661,10 @@ void spi_nor_set_fixups(struct spi_nor *nor)
>                         break;
>                 }
>         }
> +
> +       if (CONFIG_IS_ENABLED(SPI_FLASH_BAR) &&
> +           !strcmp(nor->info->name, "s25fl256l"))
> +               nor->fixups = &s25fl256l_fixups;
>  #endif

This look we have fixups for individual parts, better use default
fixup and handle it based on the part specific ID.

Jagan.

Reply via email to