Dear Peter Tyser, In message <[email protected]> you wrote: > Previously fsl_pci_init_port() always assumed that a port was a PCIe > port and would incorrectly print messages for a PCI port such as the > following on bootup: > PCI1: 32 bit, 33 MHz, sync, host, arbiter > Scanning PCI bus 00 > PCIE1 on bus 00 - 00 > > This change corrects the output of fsl_pci_init_port(): > PCI1: 32 bit, 33 MHz, sync, host, arbiter > Scanning PCI bus 00 > PCI1 on bus 00 - 00 > > Signed-off-by: Peter Tyser <[email protected]> > --- > Tested on a MPC8548 with PCI, and a MPC8640 with PCIe > > drivers/pci/fsl_pci_init.c | 6 +++++- > 1 files changed, 5 insertions(+), 1 deletions(-)
Applied, thanks. Kumar, I hope this is OK with you. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected] Very ugly or very beautiful women should be flattered on their understanding, and mediocre ones on their beauty. -- Philip Earl of Chesterfield _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
