Add the read data eye training = training for optimal read valid placement (RVTRN) when the built-in calibration is executed for LPDDR2 and LPDDR3.
This training is supported on the PUBL integrated in the STM32MP15x DDR subsystem and it is not required for DDR3. Signed-off-by: Patrick Delaunay <[email protected]> --- drivers/ram/stm32mp1/stm32mp1_ddr.c | 8 ++++++-- drivers/ram/stm32mp1/stm32mp1_ddr_regs.h | 1 + 2 files changed, 7 insertions(+), 2 deletions(-) diff --git a/drivers/ram/stm32mp1/stm32mp1_ddr.c b/drivers/ram/stm32mp1/stm32mp1_ddr.c index 0457166b12..1f8422518b 100644 --- a/drivers/ram/stm32mp1/stm32mp1_ddr.c +++ b/drivers/ram/stm32mp1/stm32mp1_ddr.c @@ -826,8 +826,12 @@ start: */ /* 10. configure PUBL PIR register to specify which training step to run */ - /* warning : RVTRN is not supported by this PUBL */ - stm32mp1_ddrphy_init(priv->phy, DDRPHYC_PIR_QSTRN); + /* RVTRN is excuted only on LPDDR2/LPDDR3 */ + if (config->c_reg.mstr & DDRCTRL_MSTR_DDR3) + pir = DDRPHYC_PIR_QSTRN; + else + pir = DDRPHYC_PIR_QSTRN | DDRPHYC_PIR_RVTRN; + stm32mp1_ddrphy_init(priv->phy, pir); /* 11. monitor PUB PGSR.IDONE to poll cpmpletion of training sequence */ ddrphy_idone_wait(priv->phy); diff --git a/drivers/ram/stm32mp1/stm32mp1_ddr_regs.h b/drivers/ram/stm32mp1/stm32mp1_ddr_regs.h index 3c8885a965..ada3087328 100644 --- a/drivers/ram/stm32mp1/stm32mp1_ddr_regs.h +++ b/drivers/ram/stm32mp1/stm32mp1_ddr_regs.h @@ -309,6 +309,7 @@ struct stm32mp1_ddrphy { #define DDRPHYC_PIR_DRAMRST BIT(5) #define DDRPHYC_PIR_DRAMINIT BIT(6) #define DDRPHYC_PIR_QSTRN BIT(7) +#define DDRPHYC_PIR_RVTRN BIT(8) #define DDRPHYC_PIR_ICPC BIT(16) #define DDRPHYC_PIR_ZCALBYP BIT(30) #define DDRPHYC_PIR_INITSTEPS_MASK GENMASK(31, 7) -- 2.25.1
