[PATCH 1/2] arm64: zynqmp: Add resets to all GEMs

[Michal Simek]

There is a need to get IP out of reset to operate properly.

Signed-off-by: Michal Simek <michal.si...@xilinx.com>
---

 arch/arm/dts/zynqmp.dtsi | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm/dts/zynqmp.dtsi b/arch/arm/dts/zynqmp.dtsi
index 07d4d4b91201..2264a80e3312 100644
--- a/arch/arm/dts/zynqmp.dtsi
+++ b/arch/arm/dts/zynqmp.dtsi
@@ -533,6 +533,7 @@
                        #stream-id-cells = <1>;
                        iommus = <&smmu 0x874>;
                        power-domains = <&zynqmp_firmware PD_ETH_0>;
+                       resets = <&zynqmp_reset ZYNQMP_RESET_GEM0>;
                };
 
                gem1: ethernet@ff0c0000 {
@@ -547,6 +548,7 @@
                        #stream-id-cells = <1>;
                        iommus = <&smmu 0x875>;
                        power-domains = <&zynqmp_firmware PD_ETH_1>;
+                       resets = <&zynqmp_reset ZYNQMP_RESET_GEM1>;
                };
 
                gem2: ethernet@ff0d0000 {
@@ -561,6 +563,7 @@
                        #stream-id-cells = <1>;
                        iommus = <&smmu 0x876>;
                        power-domains = <&zynqmp_firmware PD_ETH_2>;
+                       resets = <&zynqmp_reset ZYNQMP_RESET_GEM2>;
                };
 
                gem3: ethernet@ff0e0000 {
@@ -575,6 +578,7 @@
                        #stream-id-cells = <1>;
                        iommus = <&smmu 0x877>;
                        power-domains = <&zynqmp_firmware PD_ETH_3>;
+                       resets = <&zynqmp_reset ZYNQMP_RESET_GEM3>;
                };
 
                gpio: gpio@ff0a0000 {
-- 
2.33.1