Calling gpio_request() prior to its usage is now mandatory.
This fixes the following GPIO errors:
gpio@20a8000: set_dir_flags: error: gpio GPIO4_16 not reserved
gpio@20a8000: set_dir_flags: error: gpio GPIO4_13 not reserved
gpio@20a8000: set_dir_flags: error: gpio GPIO4_0 not reserved
gpio@20a8000: get_value: error: gpio GPIO4_13 not reserved
gpio@20a8000: get_value: error: gpio GPIO4_0 not reserved
gpio@20a0000: set_dir_flags: error: gpio GPIO2_1 not reserved
gpio@20a0000: set_value: error: gpio GPIO2_1 not reserved
Fixes: 191840ae99 ("ARM: imx: udoo_neo: Enable OF_CONTROL and DM gpio/pin
control")
Signed-off-by: Peter Robinson <[email protected]>
---
board/udoo/neo/neo.c | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/board/udoo/neo/neo.c b/board/udoo/neo/neo.c
index ce005d31cc..61195be744 100644
--- a/board/udoo/neo/neo.c
+++ b/board/udoo/neo/neo.c
@@ -249,6 +249,7 @@ static int setup_fec(void)
ARRAY_SIZE(phy_control_pads));
/* Reset PHY */
+ gpio_request(IMX_GPIO_NR(2, 1), "enet_rst");
gpio_direction_output(IMX_GPIO_NR(2, 1) , 0);
udelay(10000);
gpio_set_value(IMX_GPIO_NR(2, 1), 1);
@@ -280,6 +281,7 @@ int board_init(void)
ARRAY_SIZE(peri_3v3_pads));
/* Active high for ncp692 */
+ gpio_request(IMX_GPIO_NR(4, 16), "ncp692");
gpio_direction_output(IMX_GPIO_NR(4, 16) , 1);
#ifdef CONFIG_SYS_I2C_MXC
@@ -296,6 +298,8 @@ static int get_board_value(void)
imx_iomux_v3_setup_multiple_pads(board_recognition_pads,
ARRAY_SIZE(board_recognition_pads));
+ gpio_request(IMX_GPIO_NR(4, 13), "r184");
+ gpio_request(IMX_GPIO_NR(4, 0), "r185");
gpio_direction_input(IMX_GPIO_NR(4, 13));
gpio_direction_input(IMX_GPIO_NR(4, 0));
--
2.33.1
