On Sat, Dec 18, 2021 at 06:10:22PM -0300, Fabio Estevam wrote: > Calling gpio_request() prior to its usage is now mandatory. > > This fixes the following GPIO errors: > > U-Boot SPL 2022.01-rc3-00067-g7a5be871c0ec (Dec 18 2021 - 17:45:07 -0300) > > Trying to boot from MMC1 > > > > > > U-Boot 2022.01-rc3-00067-g7a5be871c0ec (Dec 18 2021 - 17:45:07 -0300) > > > > CPU: Freescale i.MX6Q rev1.2 at 792 MHz > > Reset cause: WDOG > > Model: Udoo i.MX6 Quad Board > > Board: Udoo Quad > > DRAM: 1 GiB > > MMC: FSL_SDHC: 2 > > Loading Environment from MMC... OK > > In: serial > > Out: serial > > Err: serial > > gpio@20a0000: set_dir_flags: error: gpio GPIO2_31 not reserved > > gpio@20a4000: set_dir_flags: error: gpio GPIO3_23 not reserved > > gpio@20b0000: set_dir_flags: error: gpio GPIO6_24 not reserved > > gpio@20b0000: set_dir_flags: error: gpio GPIO6_25 not reserved > > gpio@20b0000: set_dir_flags: error: gpio GPIO6_27 not reserved > > gpio@20b0000: set_dir_flags: error: gpio GPIO6_28 not reserved > > gpio@20b0000: set_dir_flags: error: gpio GPIO6_29 not reserved > > gpio@20a4000: set_value: error: gpio GPIO3_23 not reserved > > Net: Could not get PHY for FEC0: addr -2 > > No ethernet found. > > Signed-off-by: Fabio Estevam <[email protected]> > Reviewed-by: Peter Robinson <[email protected]>
Applied to u-boot/master, thanks! -- Tom
signature.asc
Description: PGP signature
