From: Paweł Jarosz <[email protected]> dw_mmc supports two transfer modes in u-boot: IDMA and FIFO. This patch adds auto detection of transfer mode and eliminates the need to set this in host config struct. Allow handling for a u-boot,spl-fifo-mode host property in the logic to not put the MMC controllers into FIFO mode for all time.
Signed-off-by: Paweł Jarosz <[email protected]> Signed-off-by: Johan Jonker <[email protected]> --- Changed V2: use bitfield_extract remove use_dma variable include fifo_mode from host in logic --- drivers/mmc/dw_mmc.c | 6 ++++++ include/dwmmc.h | 5 +++++ 2 files changed, 11 insertions(+) diff --git a/drivers/mmc/dw_mmc.c b/drivers/mmc/dw_mmc.c index a949dad5..7e2cd5ed 100644 --- a/drivers/mmc/dw_mmc.c +++ b/drivers/mmc/dw_mmc.c @@ -536,6 +536,12 @@ static int dwmci_init(struct mmc *mmc) return -EIO; } + if (!host->fifo_mode && + SDMMC_GET_TRANS_MODE(dwmci_readl(host, DWMCI_HCON)) == DMA_INTERFACE_IDMA) + host->fifo_mode = 0; + else + host->fifo_mode = 1; + /* Enumerate at 400KHz */ dwmci_setup_bus(host, mmc->cfg->f_min); diff --git a/include/dwmmc.h b/include/dwmmc.h index 5fc8ed83..d8d9ebe7 100644 --- a/include/dwmmc.h +++ b/include/dwmmc.h @@ -9,6 +9,7 @@ #include <asm/cache.h> #include <asm/io.h> +#include <bitfield.h> #include <mmc.h> #include <linux/bitops.h> @@ -119,6 +120,10 @@ #define RX_WMARK_SHIFT 16 #define RX_WMARK_MASK (0xfff << RX_WMARK_SHIFT) +/* HCON Register */ +#define DMA_INTERFACE_IDMA (0x0) +#define SDMMC_GET_TRANS_MODE(x) bitfield_extract(x, 16, 2) + #define DWMCI_IDMAC_OWN (1 << 31) #define DWMCI_IDMAC_CH (1 << 4) #define DWMCI_IDMAC_FS (1 << 3) -- 2.20.1
