On Wed, Mar 16, 2022 at 11:30:19AM +0100, Michael Walle wrote: > > Add pwm1/backlight support nodes for imx8mm_evk board > > > > Signed-off-by: Tommaso Merciai <[email protected]> > > --- > > arch/arm/dts/imx8mm-evk.dtsi | 21 +++++++++++++++++++++ > > 1 file changed, 21 insertions(+) > > > > diff --git a/arch/arm/dts/imx8mm-evk.dtsi b/arch/arm/dts/imx8mm-evk.dtsi > > index 60179e006d..e7a2bd8a64 100644 > > --- a/arch/arm/dts/imx8mm-evk.dtsi > > +++ b/arch/arm/dts/imx8mm-evk.dtsi > > @@ -41,6 +41,15 @@ > > enable-active-high; > > }; > > > > + backlight: backlight { > > + status = "disabled"; > > + compatible = "pwm-backlight"; > > + pwms = <&pwm1 0 5000000>; > > + brightness-levels = <0 255>; > > + num-interpolated-steps = <255>; > > + default-brightness-level = <250>; > > + }; > > + > > ir-receiver { > > compatible = "gpio-ir-receiver"; > > gpios = <&gpio1 13 GPIO_ACTIVE_LOW>; > > @@ -350,6 +359,12 @@ > > status = "okay"; > > }; > > > > +&pwm1 { > > + pinctrl-names = "default"; > > + pinctrl-0 = <&pinctrl_backlight>; > > + status = "disabled"; > > +}; > > + > > &iomuxc { > > pinctrl_fec1: fec1grp { > > fsl,pins = < > > @@ -491,4 +506,10 @@ > > MX8MM_IOMUXC_GPIO1_IO02_WDOG1_WDOG_B 0x166 > > >; > > }; > > + > > + pinctrl_backlight: backlightgrp { > > + fsl,pins = < > > + MX8MM_IOMUXC_GPIO1_IO01_PWM1_OUT 0x06 > > + >; > > + }; > > Will this also be submitted to upstream linux? Otherwise, the device > trees will diverge. > > -michael
Hi, At the moment on upstream linux, backlight on pwm1 is not handle. This will also be submitted on upstream Linux once will merged on U-Boot. Regards, Tommaso -- Tommaso Merciai Embedded Linux Engineer [email protected] __________________________________ Amarula Solutions SRL Via Le Canevare 30, 31100 Treviso, Veneto, IT T. +39 042 243 5310 [email protected] www.amarulasolutions.com
