> If vpcie-supply is defined by device-tree use that if > CONFIG_PCIE_IMX_POWER_GPIO is not defined. > Note that after this the following boards which define > CONFIG_PCIE_IMX_POWER_GPIO in their board header file as well as their > device-tree should be able to remove CONFIG_PCIE_IMX_PERST_GPIO without > consequence: > - mx6sabresd > - mx6sxsabresd > - novena > Note that the ge_bx50v3 board uses CONFIG_PCIE_IMX_POWER_GPIO and does > not have vpcie-supply defined in it's pcie node in the dt thus removing > CONFIG_PCIE_IMX_POWER_GPIO globally can't be done until that board adds > vpcie-supply. > Cc: Ian Ray <[email protected]> (maintainer:GE BX50V3 BOARD) > Cc: Sebastian Reichel <[email protected]> (maintainer:GE BX50V3 > BOARD) > Cc: Fabio Estevam <[email protected]> (maintainer:MX6SABRESD BOARD) > Cc: Marek Vasut <[email protected]> (maintainer:NOVENA BOARD) > Signed-off-by: Tim Harvey <[email protected]> Applied to u-boot-imx, master, thanks !
Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected] =====================================================================
