[PATCH 1/5] arm: mach-k3: common: Use ddr_init in spl_enable_dcache

[Georgi Vlaev]

The spl_enable_dcache() function calls dram_init_banksize()
to get the total memory size. Normally the dram_init_banksize()
setups the memory banks, while the total size is reported
by ddr_init(). This worked so far for K3 since we set the
gd->ram_size in dram_init_banksize() as well.

Signed-off-by: Georgi Vlaev <g-vl...@ti.com>
---
 arch/arm/mach-k3/common.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/mach-k3/common.c b/arch/arm/mach-k3/common.c
index b4b75f4e6c86..70f6444e7988 100644
--- a/arch/arm/mach-k3/common.c
+++ b/arch/arm/mach-k3/common.c
@@ -516,7 +516,7 @@ void spl_enable_dcache(void)
 #if !(defined(CONFIG_SYS_ICACHE_OFF) && defined(CONFIG_SYS_DCACHE_OFF))
        phys_addr_t ram_top = CONFIG_SYS_SDRAM_BASE;
 
-       dram_init_banksize();
+       dram_init();
 
        /* reserve TLB table */
        gd->arch.tlb_size = PGTABLE_SIZE;
-- 
2.30.2