On 12/23/2010 12:13 PM, Jason Liu wrote: > The early bootup information is not print out due to > the UART pin iomux not set up correctly before board_init > > Add the board_early_init_f function and enable the > CONFIG_BOARD_EARLY_INIT_F. Move the UART pin setting > from board_init to board_early_init_f function. > > This patch also move the FEC pin iomux setup to the > board_early_init_f. > > Signed-off-by: Jason Liu <[email protected]> > ---
Applied to u-boot-imx, thanks. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [email protected] ===================================================================== _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
