> From: Frieder Schrempf <[email protected]> > It turns out that it is not necessary to declare the VSELECT signal as > GPIO and let the PMIC driver set it to a fixed high level. This switches > the voltage between 3.3V and 1.8V by setting the PMIC register for LDO5 > accordingly. > Instead we can do it like other boards already do and simply mux the > VSELECT signal of the USDHC interface to the pin. This makes sure that > the correct voltage is selected by setting the PMIC's SD_VSEL input > to high or low accordingly. > Reported-by: Heiko Thiery <[email protected]> > Signed-off-by: Frieder Schrempf <[email protected]> > Reviewed-by: Heiko Thiery <[email protected]> > Reviewed-by: Fabio Estevam <[email protected]> Applied to u-boot-imx, master, thanks !
Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected] =====================================================================
