This converts the following to Kconfig:
CONFIG_SH_GPIO_PFC
CONFIG_TMU_TIMER
Signed-off-by: Tom Rini <tr...@konsulko.com>
---
arch/arm/mach-rmobile/Kconfig.32 | 4 ++++
drivers/gpio/Kconfig | 5 +++++
include/configs/rcar-gen2-common.h | 5 -----
3 files changed, 9 insertions(+), 5 deletions(-)
diff --git a/arch/arm/mach-rmobile/Kconfig.32 b/arch/arm/mach-rmobile/Kconfig.32
index a07eff71dfe7..31badc5a47dd 100644
--- a/arch/arm/mach-rmobile/Kconfig.32
+++ b/arch/arm/mach-rmobile/Kconfig.32
@@ -8,6 +8,7 @@ config RCAR_GEN2
bool "Renesas RCar Gen2"
select PHY
select PHY_RCAR_GEN2
+ select TMU_TIMER
config R8A7740
bool "Renesas SoC R8A7740"
@@ -121,6 +122,9 @@ config TARGET_STOUT
endchoice
+config TMU_TIMER
+ bool
+
config SYS_SOC
default "rmobile"
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index 1e4b50ef72b5..365615a53f7e 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -596,6 +596,11 @@ config ZYNQMP_GPIO_MODEPIN
are accessed using xilinx firmware. In modepin register, [3:0] bits
set direction, [7:4] bits read IO, [11:8] bits set/clear IO.
+config SH_GPIO_PFC
+ bool "Pinmuxed GPIO support for SuperH"
+ depends on RCAR_GEN2 && !PINCTRL_PFC
+ default y
+
config SL28CPLD_GPIO
bool "Kontron sl28cpld GPIO driver"
depends on DM_GPIO && SL28CPLD
diff --git a/include/configs/rcar-gen2-common.h
b/include/configs/rcar-gen2-common.h
index a86180ead576..291c2a43d4d9 100644
--- a/include/configs/rcar-gen2-common.h
+++ b/include/configs/rcar-gen2-common.h
@@ -10,10 +10,6 @@
#include <asm/arch/rmobile.h>
-#ifndef CONFIG_PINCTRL_PFC
-#define CONFIG_SH_GPIO_PFC
-#endif
-
/* console */
#define CFG_SYS_BAUDRATE_TABLE { 38400, 115200 }
@@ -21,7 +17,6 @@
#define CFG_SYS_SDRAM_SIZE (RCAR_GEN2_UBOOT_SDRAM_SIZE)
/* Timer */
-#define CONFIG_TMU_TIMER
#define CFG_SYS_TIMER_COUNTER (TMU_BASE + 0xc) /* TCNT0 */
#define CFG_SYS_TIMER_RATE (get_board_sys_clk() / 8)
--
2.25.1
