On 2023/1/5 03:18, Jagan Teki wrote:
For some newer SoCs like RK3568, the Rockchip has not released
any DDR drivers yet so idbloader needs to create manually using
DDR binaries offered by rkbin. This indeed no requirement to
enable TPL in the U-Boot source code.
If we mark TPL disabled and mark BINMAN enabled by default then
there would be an issue of binman_init failure during board
relocation. This is true as binman failed to find the top-level
node like u-boot-tpl here.
Here is the boot issue observed in RK3566 board,
U-Boot 2023.01-rc4-00057-gac2505d463-dirty (Jan 04 2023 - 23:44:18 +0530)
Model: Radxa Compute Module 3(CM3) IO Board
DRAM: 2 GiB
binman_init failed:-2
initcall sequence 000000007ffd2008 failed at call 0000000000a18cac (err=-2)
### ERROR ### Please RESET the board ###
This might be fixed via binman node in rockchip-u-boot.dtsi however
disable binman for rk3568 for now as we are at the end of the release
cycle.
Fixes: 05713d570762 ("rockchip: generate u-boot-rockchip.bin with binman
for ARM64 boards")
Cc: Quentin Schulz <[email protected]>
Signed-off-by: Jagan Teki <[email protected]>
---
arch/arm/Kconfig | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index cac4fa09fd..0e7a511c79 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -1934,7 +1934,7 @@ config ARCH_STM32MP
config ARCH_ROCKCHIP
bool "Support Rockchip SoCs"
select BLK
- select BINMAN if SPL_OPTEE || SPL
+ select BINMAN if SPL_OPTEE || (SPL && !ROCKCHIP_RK3568)
BINMAN should be available only when both TPL and SPL are available.
if no TPL, means there is no DDR binary available, so not able to use
binman to generate
the image.
Thanks,
- Kever
select DM
select DM_GPIO
select DM_I2C
