In commit 48ddafd (imx8mm_evk: Switch to new imx8mm evk board), the iMX8MM EVK support was updated to new EVK board which is using PCA9450A PMIC. But the commit 24a7a3c (imx8mm: synchronise device tree with linux) changed DTS node back to legacy PMIC which is not aligned with SPL codes and defconfig, then cause SPL boot failure.
Signed-off-by: Ye Li <[email protected]> --- arch/arm/dts/imx8mm-evk-u-boot.dtsi | 4 +- arch/arm/dts/imx8mm-evk.dtsi | 127 +++++++++++++++++++----------------- 2 files changed, 68 insertions(+), 63 deletions(-) diff --git a/arch/arm/dts/imx8mm-evk-u-boot.dtsi b/arch/arm/dts/imx8mm-evk-u-boot.dtsi index d82428f..951017b 100644 --- a/arch/arm/dts/imx8mm-evk-u-boot.dtsi +++ b/arch/arm/dts/imx8mm-evk-u-boot.dtsi @@ -121,11 +121,11 @@ u-boot,dm-spl; }; -&{/soc@0/bus@30800000/i2c@30a20000/pmic@4b} { +&{/soc@0/bus@30800000/i2c@30a20000/pca9450@25} { u-boot,dm-spl; }; -&{/soc@0/bus@30800000/i2c@30a20000/pmic@4b/regulators} { +&{/soc@0/bus@30800000/i2c@30a20000/pca9450@25/regulators} { u-boot,dm-spl; }; diff --git a/arch/arm/dts/imx8mm-evk.dtsi b/arch/arm/dts/imx8mm-evk.dtsi index 7d6317d..766e29a 100644 --- a/arch/arm/dts/imx8mm-evk.dtsi +++ b/arch/arm/dts/imx8mm-evk.dtsi @@ -183,115 +183,120 @@ pinctrl-0 = <&pinctrl_i2c1>; status = "okay"; - pmic@4b { - compatible = "rohm,bd71847"; - reg = <0x4b>; - pinctrl-names = "default"; + pmic: pca9450@25 { + reg = <0x25>; + compatible = "nxp,pca9450a"; + /* PMIC PCA9450 PMIC_nINT GPIO1_IO3 */ pinctrl-0 = <&pinctrl_pmic>; - interrupt-parent = <&gpio1>; - interrupts = <3 IRQ_TYPE_LEVEL_LOW>; - rohm,reset-snvs-powered; - - #clock-cells = <0>; - clocks = <&osc_32k 0>; - clock-output-names = "clk-32k-out"; + gpio_intr = <&gpio1 3 GPIO_ACTIVE_LOW>; regulators { - buck1_reg: BUCK1 { - regulator-name = "buck1"; - regulator-min-microvolt = <700000>; - regulator-max-microvolt = <1300000>; + #address-cells = <1>; + #size-cells = <0>; + + pca9450,pmic-buck2-uses-i2c-dvs; + /* Run/Standby voltage */ + pca9450,pmic-buck2-dvs-voltage = <950000>, <850000>; + + buck1_reg: regulator@0 { + reg = <0>; + regulator-compatible = "buck1"; + regulator-min-microvolt = <600000>; + regulator-max-microvolt = <2187500>; regulator-boot-on; regulator-always-on; - regulator-ramp-delay = <1250>; + regulator-ramp-delay = <3125>; }; - buck2_reg: BUCK2 { - regulator-name = "buck2"; - regulator-min-microvolt = <700000>; - regulator-max-microvolt = <1300000>; + buck2_reg: regulator@1 { + reg = <1>; + regulator-compatible = "buck2"; + regulator-min-microvolt = <600000>; + regulator-max-microvolt = <2187500>; regulator-boot-on; regulator-always-on; - regulator-ramp-delay = <1250>; - rohm,dvs-run-voltage = <1000000>; - rohm,dvs-idle-voltage = <900000>; + regulator-ramp-delay = <3125>; }; - buck3_reg: BUCK3 { - // BUCK5 in datasheet - regulator-name = "buck3"; - regulator-min-microvolt = <700000>; - regulator-max-microvolt = <1350000>; + buck3_reg: regulator@2 { + reg = <2>; + regulator-compatible = "buck3"; + regulator-min-microvolt = <600000>; + regulator-max-microvolt = <2187500>; regulator-boot-on; regulator-always-on; }; - buck4_reg: BUCK4 { - // BUCK6 in datasheet - regulator-name = "buck4"; - regulator-min-microvolt = <3000000>; - regulator-max-microvolt = <3300000>; + buck4_reg: regulator@3 { + reg = <3>; + regulator-compatible = "buck4"; + regulator-min-microvolt = <600000>; + regulator-max-microvolt = <3400000>; regulator-boot-on; regulator-always-on; }; - buck5_reg: BUCK5 { - // BUCK7 in datasheet - regulator-name = "buck5"; - regulator-min-microvolt = <1605000>; - regulator-max-microvolt = <1995000>; + buck5_reg: regulator@4 { + reg = <4>; + regulator-compatible = "buck5"; + regulator-min-microvolt = <600000>; + regulator-max-microvolt = <3400000>; regulator-boot-on; regulator-always-on; }; - buck6_reg: BUCK6 { - // BUCK8 in datasheet - regulator-name = "buck6"; - regulator-min-microvolt = <800000>; - regulator-max-microvolt = <1400000>; + buck6_reg: regulator@5 { + reg = <5>; + regulator-compatible = "buck6"; + regulator-min-microvolt = <600000>; + regulator-max-microvolt = <3400000>; regulator-boot-on; regulator-always-on; }; - ldo1_reg: LDO1 { - regulator-name = "ldo1"; + ldo1_reg: regulator@6 { + reg = <6>; + regulator-compatible = "ldo1"; regulator-min-microvolt = <1600000>; regulator-max-microvolt = <3300000>; regulator-boot-on; regulator-always-on; }; - ldo2_reg: LDO2 { - regulator-name = "ldo2"; + ldo2_reg: regulator@7 { + reg = <7>; + regulator-compatible = "ldo2"; regulator-min-microvolt = <800000>; - regulator-max-microvolt = <900000>; + regulator-max-microvolt = <1150000>; regulator-boot-on; regulator-always-on; }; - ldo3_reg: LDO3 { - regulator-name = "ldo3"; - regulator-min-microvolt = <1800000>; + ldo3_reg: regulator@8 { + reg = <8>; + regulator-compatible = "ldo3"; + regulator-min-microvolt = <800000>; regulator-max-microvolt = <3300000>; regulator-boot-on; regulator-always-on; }; - ldo4_reg: LDO4 { - regulator-name = "ldo4"; - regulator-min-microvolt = <900000>; - regulator-max-microvolt = <1800000>; + ldo4_reg: regulator@9 { + reg = <9>; + regulator-compatible = "ldo4"; + regulator-min-microvolt = <800000>; + regulator-max-microvolt = <3300000>; regulator-boot-on; regulator-always-on; }; - ldo6_reg: LDO6 { - regulator-name = "ldo6"; - regulator-min-microvolt = <900000>; - regulator-max-microvolt = <1800000>; - regulator-boot-on; - regulator-always-on; + ldo5_reg: regulator@10 { + reg = <10>; + regulator-compatible = "ldo5"; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <3300000>; }; + }; }; }; -- 2.7.4
