On Feb 2, 2011, at 11:53 AM, Haiying Wang wrote:
> On Wed, 2011-02-02 at 11:27 -0600, Kumar Gala wrote:
>> +void cpu_late_init_r(void)
>> +{
>> +#ifdef CONFIG_QE
>> + uint qe_base = CONFIG_SYS_IMMR + 0x00080000; /* QE immr base */
>> + qe_init(qe_base);
>> + qe_reset();
>> +#endif
>> +}
> You did not move qe_reset() inside qe_init() as you recommended.:)
Yeah, forgot about that. Part of this was to see what response the patch got
(ie is this even acceptable).
> For NAND boot case, the microcode needs to be read from nand flash via
> nand_read first, so you might add some more code like:
> +void cpu_late_init_r(void)
> +{
> +#ifdef CONFIG_QE
> +#ifdef CONFIG_SYS_QE_FW_IN_NAND
> + int ret;
> + size_t fw_length = CONFIG_SYS_QE_FW_LENGTH;
>
> + /* load QE firmware from NAND flash to DDR first */
> + ret = nand_read(&nand_info[0],(loff_t)CONFIG_SYS_QE_FW_IN_NAND,
> + &fw_length, (u_char *)CONFIG_SYS_QE_FW_ADDR);
>
> + if (ret && ret == -EUCLEAN) {
> + printf ("NAND read for QE firmware at offset %x failed %
> d\n",
> + CONFIG_SYS_QE_FW_IN_NAND, ret);
> + }
> +#endif
> + uint qe_base = CONFIG_SYS_IMMR + 0x00080000; /* QE immr base */
> + qe_init(qe_base);
> + qe_reset();
> +#endif
> +}
>
> Haiying
I leave that to you when we add a board (like P1021 MDS) that needs boot from
NAND.
- k
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
