OMAP2PLUS and BCM283X mmc controllers do not work correctly with new emmc code which reads partition access bits prior mmc controller reset.
So introduce a new config option MMC_ENABLE_PART_ACCESS, which is by default disabled for ARCH_OMAP2PLUS and ARCH_BCM283X; and selected for 32-bit mvebu mmc booting (which requires it). Signed-off-by: Pali Rohár <[email protected]> --- arch/arm/mach-mvebu/Kconfig | 1 + drivers/mmc/Kconfig | 12 ++++++++++++ drivers/mmc/mmc.c | 2 ++ 3 files changed, 15 insertions(+) diff --git a/arch/arm/mach-mvebu/Kconfig b/arch/arm/mach-mvebu/Kconfig index ac484c73f62d..fe691cd435e7 100644 --- a/arch/arm/mach-mvebu/Kconfig +++ b/arch/arm/mach-mvebu/Kconfig @@ -353,6 +353,7 @@ config MVEBU_SPL_BOOT_DEVICE_MMC imply SPL_GPIO imply SPL_LIBDISK_SUPPORT imply SPL_MMC + select MMC_ENABLE_PART_ACCESS if SPL_MMC select SUPPORT_EMMC_BOOT if SPL_MMC select SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR if SPL_MMC select SPL_BOOTROM_SUPPORT diff --git a/drivers/mmc/Kconfig b/drivers/mmc/Kconfig index de01b9687bad..ea50dfdb62c5 100644 --- a/drivers/mmc/Kconfig +++ b/drivers/mmc/Kconfig @@ -107,6 +107,18 @@ config MMC_HW_PARTITIONING This adds a command and an API to do hardware partitioning on eMMC devices. +config MMC_ENABLE_PART_ACCESS + bool "Support for MMC partition access bits" + default n if ARCH_OMAP2PLUS || ARCH_BCM283X + default y + help + Read partition access bits from partition config register before card reset command + because these bits are reset to default value (User Data Area) during card reset. + This allows us to preserve original value of partition access bits used by the code + which loaded us (for example BootROM) and use it for board specific boot purposes. + . + This is required when U-Boot is using EXT_CSD_EXTRACT_PARTITION_ACCESS macro. + config SUPPORT_EMMC_RPMB bool "Support eMMC replay protected memory block (RPMB)" imply CMD_MMC_RPMB diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c index 9915610d82b1..fa3c4d1937c1 100644 --- a/drivers/mmc/mmc.c +++ b/drivers/mmc/mmc.c @@ -2864,6 +2864,7 @@ int mmc_get_op_cond(struct mmc *mmc, bool quiet) retry: mmc_set_initial_state(mmc); +#ifdef CONFIG_MMC_ENABLE_PART_ACCESS /* * Read partition access bits from partition config register before card reset command * because these bits are reset to default value (User Data Area) during card reset. @@ -2878,6 +2879,7 @@ retry: ext_csd[EXT_CSD_BOOT_MULT])) mmc->part_config = ext_csd[EXT_CSD_PART_CONF] & PART_ACCESS_MASK; } +#endif /* Reset the Card */ err = mmc_go_idle(mmc); -- 2.20.1
