On Tue, Aug 22, 2023 at 9:34 AM Shengyu Qu <wiagn...@outlook.com> wrote:
> Although PCIE driver already exists, board defconfig isn't configured to > enable PCIE enum on boot, thus USB storage device and NVME drive are not > supported by default. So modify defconfig to enable PCIE auto enum, then > start USB subsystem and scan nvme drive on boot. > > Signed-off-by: Shengyu Qu <wiagn...@outlook.com> > Tested-by: Dennis Gilmore <den...@ausil.us> > --- > configs/starfive_visionfive2_defconfig | 8 +++++++- > 1 file changed, 7 insertions(+), 1 deletion(-) > > diff --git a/configs/starfive_visionfive2_defconfig > b/configs/starfive_visionfive2_defconfig > index e9b63e5b84..3002c96f0e 100644 > --- a/configs/starfive_visionfive2_defconfig > +++ b/configs/starfive_visionfive2_defconfig > @@ -30,6 +30,7 @@ CONFIG_SPL_SPI=y > CONFIG_SYS_LOAD_ADDR=0x82000000 > CONFIG_SYS_PCI_64BIT=y > CONFIG_PCI=y > +CONFIG_PCI_INIT_R=y > CONFIG_TARGET_STARFIVE_VISIONFIVE2=y > CONFIG_SPL_OPENSBI_LOAD_ADDR=0x40000000 > CONFIG_ARCH_RV64I=y > @@ -43,7 +44,7 @@ CONFIG_SD_BOOT=y > CONFIG_USE_BOOTARGS=y > CONFIG_BOOTARGS="console=ttyS0,115200 debug rootwait earlycon=sbi" > CONFIG_USE_PREBOOT=y > -CONFIG_PREBOOT="setenv fdt_addr ${fdtcontroladdr};fdt addr > ${fdtcontroladdr};" > +CONFIG_PREBOOT="nvme scan; usb start; setenv fdt_addr ${fdtcontroladdr}; > fdt addr ${fdtcontroladdr};" > CONFIG_DEFAULT_FDT_FILE="starfive/jh7110-starfive-visionfive-2.dtb" > CONFIG_DISPLAY_CPUINFO=y > CONFIG_DISPLAY_BOARDINFO=y > @@ -124,4 +125,9 @@ CONFIG_TIMER_EARLY=y > CONFIG_USB=y > CONFIG_USB_XHCI_HCD=y > CONFIG_USB_XHCI_PCI=y > +CONFIG_USB_EHCI_HCD=y > +CONFIG_USB_EHCI_PCI=y > +CONFIG_USB_OHCI_HCD=y > +CONFIG_USB_OHCI_PCI=y > +CONFIG_USB_STORAGE=y > CONFIG_USB_KEYBOARD=y > -- > 2.42.0 > >