zynqmp-power node is going to be renamed to power-management which should be generic enough. New name came from dt-binding review that's why there is no way around. Add support new name but also at the same time check old name just in case older dt binding is used.
Signed-off-by: Michal Simek <[email protected]> --- DT patch is available here: https://lore.kernel.org/all/a2f7fe30e3630c262c2773a595b7a0c8918573a0.1704359569.git.michal.si...@amd.com/ --- board/xilinx/zynqmp/zynqmp.c | 9 ++++++--- 1 file changed, 6 insertions(+), 3 deletions(-) diff --git a/board/xilinx/zynqmp/zynqmp.c b/board/xilinx/zynqmp/zynqmp.c index e3700f076bc1..9f5009072025 100644 --- a/board/xilinx/zynqmp/zynqmp.c +++ b/board/xilinx/zynqmp/zynqmp.c @@ -156,9 +156,12 @@ int board_init(void) #if defined(CONFIG_ZYNQMP_FIRMWARE) struct udevice *dev; - uclass_get_device_by_name(UCLASS_FIRMWARE, "zynqmp-power", &dev); - if (!dev) - panic("PMU Firmware device not found - Enable it"); + uclass_get_device_by_name(UCLASS_FIRMWARE, "power-management", &dev); + if (!dev) { + uclass_get_device_by_name(UCLASS_FIRMWARE, "zynqmp-power", &dev); + if (!dev) + panic("PMU Firmware device not found - Enable it"); + } #endif #if defined(CONFIG_SPL_BUILD) -- 2.36.1
