Hi, as requested [1]:
Tested-by: Jens Maus <m...@jens-maus.de <mailto:m...@jens-maus.de>> best regards, jens [1] https://lists.denx.de/pipermail/u-boot/2024-January/544243.html > Am 23.01.2024 um 09:07 schrieb Ivan T. Ivanov <iiva...@suse.de>: > > This is new round of patches posted earlier here[1]. They are adding basic > support for RPi5 and are based on v2 series from Dmitry Malkin[2]. > > What changed sice v4: > > * Support for SDHCI controller in 2712 was simplified a lot. It turns out > that special registers accessors are not needed[3]. > > * Latest EEPROM firmware changed "kernel" load address from 0x80000 > to 0x200000. And because on RPi’s CONFIG_TEXT_BASE is set to 0x80000 > code execution run through the grass. Switching to position indeended > code fixed this. > > These changes have been tested on following devices: > > Raspberry Pi 5 Model B Rev 1.0 > Raspberry Pi 4 Model B Rev 1.1 > Raspberry Pi 3 Model B Plus Rev 1.3 > Raspberry Pi Zero 2 W Rev 1.0 > Raspberry Pi 2 Model B Rev 1.2 > Raspberry Pi Compute Module 4 Rev 1.0 > Raspberry Pi Compute Module 3 Rev 1.0 > > Thanks, > Ivan > > [1] https://lore.kernel.org/all/20240110122908.31612-1-iiva...@suse.de/ > [2] > https://lore.kernel.org/all/CAKRNjQ0dsWozGo4n8g58m4cCEk3n=qx1r+l24wbgpo-ip1y...@mail.gmail.com/ > [3] > https://github.com/P33M/linux/commit/8a15e5d99667cb4499836d6f360246a69f020256 > > > Dmitry Malkin (2): > rpi5: add initial memory map for bcm2712 > rpi5: Use devicetree as alternative way to read IO base addresses > > Ivan T. Ivanov (5): > rpi5: Use devicetree to retrieve board revision > bcm2835: Dynamically calculate bytes per pixel parameter > mmc: bcmstb: Add support for bcm2712 SD controller > configs: rpi_arm64: enable SDHCI BCMSTB driver > configs: rpi_arm64: build position independent code > > arch/arm/mach-bcm283x/include/mach/base.h | 5 +- > arch/arm/mach-bcm283x/include/mach/mbox.h | 3 +- > arch/arm/mach-bcm283x/include/mach/sdhci.h | 3 +- > arch/arm/mach-bcm283x/include/mach/timer.h | 3 +- > arch/arm/mach-bcm283x/include/mach/wdog.h | 3 +- > arch/arm/mach-bcm283x/init.c | 74 +++++++++++++++++++--- > board/raspberrypi/rpi/rpi.c | 22 ++++++- > configs/rpi_arm64_defconfig | 3 +- > drivers/mmc/bcmstb_sdhci.c | 64 +++++++++++++++++-- > drivers/video/bcm2835.c | 18 +++++- > 10 files changed, 171 insertions(+), 27 deletions(-) > > -- > 2.43.0 > -- Jens Maus, Dresden/Germany http://jens-maus.de/