From: Huber, Andreas <andreas.hu...@keymile.com>
This reads the DIP switch register in the BFTICU (0x40000089). If 'Full reset'
or 'DB erase' is selected, 'actual_bank' is set to 0. This loads the Bootloader
application who does the erase stuff. To access the register a struct for the
bfticu I/O map was added to common.h.
Signed-off-by: Andreas Huber <andreas.hu...@keymile.com>
Signed-off-by: Holger Brunck <holger.bru...@keymile.com>
Acked-by: Heiko Schocher <h...@denx.de>
cc: Wolfgang Denk <w...@denx.de>
cc: Detlev Zundel <d...@denx.de>
cc: Valentin Longchamp <valentin.longch...@keymile.com>
Signed-off-by: Valentin Longchamp <valentin.longch...@keymile.com>
---
board/keymile/common/common.h | 79 +++++++++++++++++++++++++++++++++++++++++
board/keymile/mgcoge/mgcoge.c | 12 ++++++
2 files changed, 91 insertions(+), 0 deletions(-)
diff --git a/board/keymile/common/common.h b/board/keymile/common/common.h
index 099de98..cdc35b6 100644
--- a/board/keymile/common/common.h
+++ b/board/keymile/common/common.h
@@ -39,6 +39,85 @@ struct km_bec_fpga {
unsigned char pgy_eth;
};
+#define BFTICU_DIPSWITCH_MASK 0x0f
+
+/*
+ * BFTICU FPGA iomap
+ * BFTICU is used on mgcoge and mgocge3ne
+ */
+struct bfticu_iomap {
+ u8 xi_ena; /* General defect enable */
+ u8 pack1[3];
+ u8 en_csn;
+ u8 pack2;
+ u8 safe_mem;
+ u8 pack3;
+ u8 id;
+ u8 pack4;
+ u8 rev;
+ u8 build;
+ u8 p_frc;
+ u8 p_msk;
+ u8 pack5[2];
+ u8 xg_int;
+ u8 pack6[15];
+ u8 s_conf;
+ u8 pack7;
+ u8 dmx_conf12;
+ u8 pack8;
+ u8 s_clkslv;
+ u8 pack9[11];
+ u8 d_conf;
+ u8 d_mask_ca;
+ u8 d_pll_del;
+ u8 pack10[16];
+ u8 t_conf_ca;
+ u8 t_mask_ca;
+ u8 pack11[13];
+ u8 m_def0;
+ u8 m_def1;
+ u8 m_def2;
+ u8 m_def3;
+ u8 m_def4;
+ u8 m_def5;
+ u8 m_def_trap0;
+ u8 m_def_trap1;
+ u8 m_def_trap2;
+ u8 m_def_trap3;
+ u8 m_def_trap4;
+ u8 m_def_trap5;
+ u8 m_mask_def0;
+ u8 m_mask_def1;
+ u8 m_mask_def2;
+ u8 m_mask_def3;
+ u8 m_mask_def4;
+ u8 m_mask_def5;
+ u8 m_def_mask0;
+ u8 m_def_mask1;
+ u8 m_def_mask2;
+ u8 m_def_mask3;
+ u8 m_def_mask4;
+ u8 m_def_mask5;
+ u8 m_def_pri;
+ u8 pack12[11];
+ u8 hw_status;
+ u8 pack13;
+ u8 hw_control1;
+ u8 hw_control2;
+ u8 hw_control3;
+ u8 pack14[7];
+ u8 led_on; /* Leds */
+ u8 pack15;
+ u8 sfp_control; /* SFP modules */
+ u8 pack16;
+ u8 alarm_control; /* Alarm output */
+ u8 pack17;
+ u8 icps; /* ICN clock pulse shaping */
+ u8 mswitch; /* Read mode switch */
+ u8 pack18[6];
+ u8 pb_dbug;
+};
+
#if !defined(CONFIG_PIGGY_MAC_ADRESS_OFFSET)
#define CONFIG_PIGGY_MAC_ADRESS_OFFSET 0
#endif
diff --git a/board/keymile/mgcoge/mgcoge.c b/board/keymile/mgcoge/mgcoge.c
index 340016b..11a0f79 100644
--- a/board/keymile/mgcoge/mgcoge.c
+++ b/board/keymile/mgcoge/mgcoge.c
@@ -315,6 +315,18 @@ int board_early_init_r(void)
int last_stage_init(void)
{
+ struct bfticu_iomap *base =
+ (struct bfticu_iomap *)CONFIG_SYS_FPGA_BASE;
+ u8 dip_switch;
+
+ dip_switch = in_8(&base->mswitch);
+ dip_switch &= BFTICU_DIPSWITCH_MASK;
+ /* dip switch 'full reset' or 'db erase' */
+ if (dip_switch & 0x1 || dip_switch & 0x2) {
+ /* start bootloader */
+ puts("DIP: Enabled\n");
+ setenv("actual_bank", "0");
+ }
set_km_env();
return 0;
}
--
1.7.0.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
