From: Lukasz Czechowski <lukasz.czechow...@thaumatec.com>
Display TPL init information message only when TPL_BANNER_PRINT
configuration entry is set. This allows to disable information
message in case logs on UART are unwanted.
Update parent ifdef condition to check also CONFIG_TPL_SERIAL
to match logic of the non-PX30 TPL implementation.
Signed-off-by: Lukasz Czechowski <lukasz.czechow...@thaumatec.com>
Cc: Tom Rini <tr...@konsulko.com>
Cc: Simon Glass <s...@chromium.org>
Cc: Philipp Tomsich <philipp.toms...@vrull.eu>
Cc: Kever Yang <kever.y...@rock-chips.com>
---
Changes for v2:
- Updated parent ifdef condition
---
arch/arm/mach-rockchip/px30-board-tpl.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/arch/arm/mach-rockchip/px30-board-tpl.c
b/arch/arm/mach-rockchip/px30-board-tpl.c
index 637a5e1b18..db368a7b8c 100644
--- a/arch/arm/mach-rockchip/px30-board-tpl.c
+++ b/arch/arm/mach-rockchip/px30-board-tpl.c
@@ -36,7 +36,7 @@ void board_init_f(ulong dummy)
{
int ret;
-#ifdef CONFIG_DEBUG_UART
+#if defined(CONFIG_DEBUG_UART) && defined(CONFIG_TPL_SERIAL)
debug_uart_init();
/*
* Debug UART can be used from here if required:
@@ -46,7 +46,9 @@ void board_init_f(ulong dummy)
* printhex8(0x1234);
* printascii("string");
*/
+#if CONFIG_TPL_BANNER_PRINT
printascii("U-Boot TPL board init\n");
+#endif
#endif
secure_timer_init();
--
2.34.1
