On 05/19/11 11:12, James Harris wrote: > Hi Igor, > > Thanks for your prompt response. > I've made similar modifications to the omap5912osk over the past number of > days with no success...
:( > The problem appears deeper than just providing these definitions, which as > you say, requires actual hardware to test with :) Exactly, I had to make it compile so I can compile test some other patch. So I took some values from another board with the same SoC that looked sane to me. And put there a "FIXME" comment... > I've gone back to 2010.09 release and it now works very nicely! > > I chose that version as it is just prior to the relocation changes applied in > the arch/arm/cpu/arm926ejs/start.S file: > 2010-09-19 Heiko Schocher ARM: implement relocation for ARM926 > > That change would certainly cause out-of-box compilation failures, however I > am not sure whether it was that change or possibly the following change: > 2010-10-13 Albert Aribaud arm: implement ELF relocations > that causes the runtime failure... Added Heiko and Albert to cc. > I may investigate further, however, at this stage I can "move on" using the > 2010.09 release. > > As an aside: Using U-Boot 2010.09 also resolves a problem I was having with > u-boot V1.1.1: > The V2.6.32 linux kernel could not be booted when mem=32M was passed using > u-boot V1.1.1 > However when I tried earlier today, through pure desperation, passing mem=16M > it did boot. > Now under u-boot 2010.09 the Linux kernel boots just fine with mem=32M > > Cheers, > > James > > > ....................................................................... > > James Harris > > T +61 8 8104 5253 > E [email protected] > ....................................................................... > > -----Original Message----- > From: Igor Grinberg [mailto:[email protected]] > Sent: Thursday, 19 May 2011 5:09 PM > To: James Harris > Cc: [email protected]; [email protected] > Subject: Re: [U-Boot] OMAP5912 -- Status? > > Hi James, > > On 05/19/11 10:07, James Harris wrote: > >> Greetings all, >> >> >> >> Over the past few days I've been trying to get u-boot 2011.03 for the >> omap5912osk working. >> >> >> >> Support for the target appears to have stagnated... >> >> >> >> "Out of the box" the omap5912osk (and omap1610inn) target fails to >> compile due to the following missing symbols: >> >> CONFIG_SYS_SDRAM_BASE >> >> CONFIG_SYS_INIT_SP_ADDR > I've send a patch [1] which hopefully fixes omap1610inn and omap1610h2. > I can't test is as I don't have this hardware. > It is currently waiting for Sandeep's approval. > > [1] > http://www.mail-archive.com/[email protected]/msg52157.html > > > > -- > Regards, > Igor. > > -- Regards, Igor. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
