Current usage information for loads command is too verbose and long for a command usage prompt. This flag simplifies the text for readability purposes.
Signed-off-by: Ibai Erkiaga <[email protected]> --- (no changes since v1) cmd/fpga.c | 21 ++++++++------------- 1 file changed, 8 insertions(+), 13 deletions(-) diff --git a/cmd/fpga.c b/cmd/fpga.c index ae85ff201b8..91ccbee0fef 100644 --- a/cmd/fpga.c +++ b/cmd/fpga.c @@ -434,18 +434,13 @@ U_BOOT_CMD(fpga, 6, 1, do_fpga_wrapper, #endif #endif #if defined(CONFIG_CMD_FPGA_LOAD_SECURE) - "fpga loads <dev> <address> <size> <auth-OCM-0/DDR-1/noauth-2>\n" - " <enc-devkey(0)/userkey(1)/nenc(2> [Userkey address]\n" - " Loads the secure bistreams(authenticated/encrypted/both\n" - " authenticated and encrypted) of [size] from [address]\n" - " (Xilinx only)\n" - " -The auth-OCM/DDR flag specifies to perform authentication\n" - " in OCM or in DDR. 0 for OCM, 1 for DDR, 2 for no authentication\n" - " -The enc flag specifies which key to be used for decryption\n" - " 0-device key, 1-user key, 2-no encryption.\n" - " -The optional Userkey address specifies from which address key\n" - " has to be used for decryption if user key is selected.\n" - " NOTE: the secure bitstream has to be created using Xilinx\n" - " bootgen tool only.\n" + "fpga loads <dev> <address> <size> <authflag> <encflag> [Userkey address]\n" + " Load device from memory buffer with secure bistream\n" + " (authenticated/encrypted/both)(Xilinx only)\n" + " -authflag: 0 for OCM, 1 for DDR, 2 for no authentication\n" + " (specifies where to perform authentication)\n" + " -encflag: 0 for device key, 1 for user key, 2 for no encryption\n" + " -Userkey address: address where user key is stored\n" + " NOTE: secure bitstream has to be created using Xilinx bootgen tool\n" #endif ); -- 2.42.0.325.g3a06386e31
