From: Prasad Kummari <[email protected]> Output images are generated via Binman only if SPL is enabled, as there is no consumer for them otherwise. An #ifdef check ensures that when SPL is enabled, Binman generates the U-Boot ITB. If SPL is disabled, ITB generation is skipped since the ITB format is supported only by SPL. Without SPL, generating such an image is unnecessary, as it would not be used
The second reason is that when a DTB is passed, the current logic cannot handle it without an additional step in U-Boot to parse an appended FIT image and enable board-specific code to select the correct DTB config. The MULTI_DTB_FIT configuration should be used if support for multiple DTBs is required, but SPL is not being used. Signed-off-by: Prasad Kummari <[email protected]> Signed-off-by: Michal Simek <[email protected]> --- arch/arm/dts/zynqmp-binman-som.dts | 3 +++ arch/arm/dts/zynqmp-binman.dts | 2 ++ 2 files changed, 5 insertions(+) diff --git a/arch/arm/dts/zynqmp-binman-som.dts b/arch/arm/dts/zynqmp-binman-som.dts index 3d9d8476c98e..3ffa06f0c04f 100644 --- a/arch/arm/dts/zynqmp-binman-som.dts +++ b/arch/arm/dts/zynqmp-binman-som.dts @@ -13,6 +13,8 @@ / { binman: binman { multiple-images; + +#ifdef CONFIG_SPL fit-dtb.blob { filename = "fit-dtb.blob"; pad-byte = <0>; @@ -220,6 +222,7 @@ fdtmap { }; }; +#endif #endif }; }; diff --git a/arch/arm/dts/zynqmp-binman.dts b/arch/arm/dts/zynqmp-binman.dts index 675f6bf51ebd..bf3335a3e539 100644 --- a/arch/arm/dts/zynqmp-binman.dts +++ b/arch/arm/dts/zynqmp-binman.dts @@ -14,6 +14,7 @@ binman: binman { multiple-images; +#ifdef CONFIG_SPL /* u-boot.itb generation in a static way */ itb { filename = "u-boot.itb"; @@ -201,6 +202,7 @@ fdtmap { }; }; +#endif #endif }; }; -- 2.43.0
