The clock driver allows to boost the NAND performance
controller. Make changes to let it use the new clock driver
=> time nand read ${loadaddr} kernel
NAND read: device 0 offset 0x500000, size 0x800000
8388608 bytes read: OK
time: 0.488 seconds
Signed-off-by: Michael Trimarchi <mich...@amarulasolutions.com>
---
Changes in v4:
- None
Changes in v3:
- None
Changes in v2:
- Adjust commit message and include speed test result
- remove not needed { }
drivers/mtd/nand/raw/mxs_nand.c | 10 ++++++++++
drivers/mtd/nand/raw/mxs_nand_dt.c | 2 +-
2 files changed, 11 insertions(+), 1 deletion(-)
diff --git a/drivers/mtd/nand/raw/mxs_nand.c b/drivers/mtd/nand/raw/mxs_nand.c
index 80d9307cdd1..ba67466069b 100644
--- a/drivers/mtd/nand/raw/mxs_nand.c
+++ b/drivers/mtd/nand/raw/mxs_nand.c
@@ -1507,8 +1507,18 @@ static void mxs_compute_timings(struct nand_chip *chip,
writel(GPMI_CTRL1_CLEAR_MASK, &nand_info->gpmi_regs->hw_gpmi_ctrl1_clr);
writel(ctrl1n, &nand_info->gpmi_regs->hw_gpmi_ctrl1_set);
+ /* Clock dividers do NOT guarantee a clean clock signal on its output
+ * during the change of the divide factor on i.MX6Q/UL/SX. On i.MX7/8,
+ * all clock dividers provide these guarantee.
+ */
+ if (IS_ENABLED(CONFIG_MX6ULL))
+ clk_disable(nand_info->gpmi_clk);
+
clk_set_rate(nand_info->gpmi_clk, clk_rate);
+ if (IS_ENABLED(CONFIG_MX6ULL))
+ clk_enable(nand_info->gpmi_clk);
+
/* Wait 64 clock cycles before using the GPMI after enabling the DLL */
dll_wait_time_us = USEC_PER_SEC / clk_rate * 64;
if (!dll_wait_time_us)
diff --git a/drivers/mtd/nand/raw/mxs_nand_dt.c
b/drivers/mtd/nand/raw/mxs_nand_dt.c
index b62474bc5ab..90eefa2558d 100644
--- a/drivers/mtd/nand/raw/mxs_nand_dt.c
+++ b/drivers/mtd/nand/raw/mxs_nand_dt.c
@@ -99,7 +99,7 @@ static int mxs_nand_dt_probe(struct udevice *dev)
info->use_minimum_ecc = dev_read_bool(dev, "fsl,use-minimum-ecc");
if (IS_ENABLED(CONFIG_CLK) &&
- (IS_ENABLED(CONFIG_IMX8) || IS_ENABLED(CONFIG_IMX8M))) {
+ (IS_ENABLED(CONFIG_IMX8) || IS_ENABLED(CONFIG_IMX8M) ||
IS_ENABLED(CONFIG_MX6ULL))) {
struct clk_bulk clk_bulk;
info->gpmi_clk = devm_clk_get(dev, "gpmi_io");
--
2.43.0
base-commit: df2ed552f0b05591090369a7fe7ddc92439dea5c
