The support found under SYS_FAULT_ECHO_LINK_DOWN requires that the SYS_FAULT_MII_ADDR symbol also be set. This wasn't previously found in Kconfig, so add it now.
Signed-off-by: Tom Rini <[email protected]> --- Cc: Jerome Forissier <[email protected]> Changes in v2: - Add missing dependency on LED_STATUS_RED_ENABLE as well. --- README | 3 --- net/Kconfig | 4 ++++ 2 files changed, 4 insertions(+), 3 deletions(-) diff --git a/README b/README index 07cfded6be53..27cde241bef4 100644 --- a/README +++ b/README @@ -1238,9 +1238,6 @@ Note: once the monitor has been relocated, then it will complain if the default environment is used; a new CRC is computed as soon as you use the "saveenv" command to store a valid environment. -- CONFIG_SYS_FAULT_MII_ADDR: - MII address of the PHY to check for the Ethernet link state. - - CONFIG_DISPLAY_BOARDINFO Display information about the board that U-Boot is running on when U-Boot starts up. The board function checkboard() is called diff --git a/net/Kconfig b/net/Kconfig index 40ec6bbce761..5768fab6f8fb 100644 --- a/net/Kconfig +++ b/net/Kconfig @@ -60,6 +60,10 @@ config SYS_FAULT_ECHO_LINK_DOWN this option is active, then CONFIG_SYS_FAULT_MII_ADDR also needs to be configured. +config SYS_FAULT_MII_ADDR + hex "MII address of the PHY to check for the Ethernet link state" + depends on SYS_FAULT_ECHO_LINK_DOWN && LED_STATUS_RED_ENABLE + config TFTP_PORT bool "Set TFTP UDP source/destination ports via the environment" help -- 2.43.0
