On Thu, Jul 14, 2011 at 09:45:37PM +0200, Wolfgang Denk wrote: > Dear "Ira W. Snyder", > > In message <[email protected]> you wrote: > > > > Does anyone have a BDI2000 configuration for the P2020DS that they could > > share with me? > > Abatron ships a p2020ds.cfg with their firmware for the BDI. Do you > think this is not working or not good enough? >
It says, right at the top: ; The values used to configure the memory controller ; are the ones U-boot uses to setup my system. ; Your system may need different ones !!! ; ; This configuration is not usable for U-boot debugging. ; Use it to debug example code loaded into SDRAM. I'm hoping for a configuration that can program the flash on a bricked board. Then I can flash anything I want without fear of rendering an expensive board useless. > > The documentation Freescale sent me claims that U-Boot is in a 4MB SPI > > flash, however, the U-Boot that came with the board is unable to > > initialize the SPI subsystem per their instructions. > ... > > I thought I'd use the BDI2000 to dump a copy of their U-Boot before I > > replace it with my own, just for good measure. > > Well, if it's really in SPI flash, then the BDI will not help you to > dump it. The BDI cannot access SPI flash directly. > Thanks for the information. Ira _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
