Le 30/08/2011 18:23, Simon Glass a écrit :
> This patch series adds basic clock and pinmux functions to the Tegra2, and
> modifies the ap20 and board code to use them.
>
> Changes in v2:
> - Removed use of bitfield access macros
> - Now uses manual shifts and masks
>
> Changes in v3:
> - Removed bitfield shift/mask macros and write these out manually
> - Rebased to take account to new MMC patches
> - Remove future time function
> - No microsecond timing changes as I am unsure of the state of this in U-Boot
>
> Changes in v4:
> - Rebase against U-Boot master
> - Remove future time function from header also
>
> Simon Glass (4):
> Tegra2: Add microsecond timer function
> Tegra2: Add more clock support
> Tegra2: Add additional pin multiplexing features
> Tegra2: Use clock and pinmux functions to simplify code
Patch series applied to u-boot-arm/master, with manual fix of three
empty lines at EOF in patches 1 through 3.
These empty lines and other whitespace errors can be found and fixed by
the submitter before sending the patch to the list: just apply the
patches to a local branch created at the intended commit where
application will happen, i.e.:
git fetch u-boot
or
git fetch u-boot-arm
(assuming you have a remote nicknamed u-boot[-arm])
git checkout u-boot/master -b temp
or
git checkout u-boot-arm/master -b temp
git am 0001-xxxxx
git am 0002-xxxxx
(etc)
If any empty line or bad whitespace warning occurs, go back to your
working branch, fix and regenerate the patch set, then go back to temp
and reset it:
git checkout temp
git reset --hard u-boot/master
or
git reset u-boot-arm/master
Then you can run the
git am 0001-xxxxx
...
again.
When the patches are sent, you can go back to your working branch and
then do a
git branch -D temp
to remove the temporary branch.
Amicalement,
--
Albert.
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
