This patch contains the generic changes required after change to generic API in the previous patch.
Signed-off-by: Sanjeev Premi <[email protected]> Cc: Sandeep Paulraj <[email protected]> Cc: Igor Grinberg <[email protected]> Cc: Luca Ceresoli <[email protected]> Cc: Enric Balletbo i Serra <[email protected]> Cc: Sunil Kumar <[email protected]> Cc: Shashi Ranjan <[email protected]> Cc: Nishanth Menon <[email protected]> Cc: Steve Sakoman <[email protected]> --- These changes could have been merged with the previous patch, but kept changes to API separate from the usage. arch/arm/cpu/armv7/omap4/clocks.c | 4 ++-- doc/README.omap3 | 20 ++++++++++---------- 2 files changed, 12 insertions(+), 12 deletions(-) diff --git a/arch/arm/cpu/armv7/omap4/clocks.c b/arch/arm/cpu/armv7/omap4/clocks.c index eda960c..56cdbe4 100644 --- a/arch/arm/cpu/armv7/omap4/clocks.c +++ b/arch/arm/cpu/armv7/omap4/clocks.c @@ -481,8 +481,8 @@ static void do_scale_tps62361(u32 reg, u32 volt_mv) * VSEL1 is grounded on board. So the following selects * VSEL1 = 0 and VSEL0 = 1 */ - omap_set_gpio_direction(TPS62361_VSEL0_GPIO, 0); - omap_set_gpio_dataout(TPS62361_VSEL0_GPIO, 1); + gpio_direction_output(TPS62361_VSEL0_GPIO); + gpio_set_value(TPS62361_VSEL0_GPIO, 1); temp = TPS62361_I2C_SLAVE_ADDR | (reg << PRM_VC_VAL_BYPASS_REGADDR_SHIFT) | diff --git a/doc/README.omap3 b/doc/README.omap3 index 460950d..2a18133 100644 --- a/doc/README.omap3 +++ b/doc/README.omap3 @@ -98,24 +98,24 @@ gpio To set a bit : - if (!omap_request_gpio(N)) { - omap_set_gpio_direction(N, 0); - omap_set_gpio_dataout(N, 1); + if (!gpio_request(N, "")) { + gpio_direction_output(N); + gpio_set_value(N, 1); } To clear a bit : - if (!omap_request_gpio(N)) { - omap_set_gpio_direction(N, 0); - omap_set_gpio_dataout(N, 0); + if (!gpio_request(N, "")) { + gpio_direction_output(N); + gpio_set_value(N, 0); } To read a bit : - if (!omap_request_gpio(N)) { - omap_set_gpio_direction(N, 1); - val = omap_get_gpio_datain(N); - omap_free_gpio(N); + if (!gpio_request(N, "")) { + gpio_direction_input(N); + val = gpio_get_value(N); + gpio_free(N); } if (val) printf("GPIO N is set\n"); -- 1.7.0.4 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
