On Thu, Oct 13, 2011 at 1:18 AM, Aneesh V <ane...@ti.com> wrote: >> Perhaps it is a board rev issue. > > Yes it is. SPL works on everything other than a Panda with OMAP4430 > ES2.0. I could reproduce it on an ES2.0 Panda. Please note that an SDP > with OMAP4430 ES2.0 works too, which is rather strange. At the outset, > it looked like a memory issue so I used > CONFIG_SYS_EMIF_PRECALCULATED_TIMING_REGS, which removed memory check > failure. However, it still fails at the same point. The fact that > Lauterbach is not working on my board is not helping my investigations. > Also, the only ES2.0 Panda I could find here is also being used by > another person. So, I have to time-share it with him. I will try to > investigate it further today as soon as I get the board.
Thanks for looking at this Aneesh! I too tried both computed and precalculated timing and found that both failed. X-loader works on my board so I have begun comparing the setup between x-loader and u-boot-spl. There are definitely differences in the register setup. Will spend some more time on this tomorrow. Steve _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
