On 10/26/2011 10:25 AM, Stefano Babic wrote: > On 10/25/2011 05:25 PM, Marek Vasut wrote: >> The problem was caused by a global variable being used early in the boot >> process. >> >> The symptoms were on imx31_phycore board, reading the environment from I2C >> EEPROM didn't work correctly and causes default environment to be loaded. >> >> Signed-off-by: Marek Vasut <[email protected]> >> Cc: Wolfgang Denk <[email protected]> >> Cc: Albert ARIBAUD <[email protected]> >> Cc: Heiko Schocher <[email protected]> >> Cc: Stefano Babic <[email protected]> >> Tested-by: Anatolij Gustschin <[email protected]> >> --- >> drivers/i2c/mxc_i2c.c | 29 ++++++++++++++++------------- >> 1 files changed, 16 insertions(+), 13 deletions(-) >> >> V2: Fix commit message > > Tested on mx35pdk. > > Tested-by: Stefano Babic <[email protected]>
I tested (and it works), but there is a problem. I supposed it was a mistake by me, but after some checks I have found the cause. Your patch does not apply on current u-boot-imx. You sent earlier the patch: "I2C: Add i2c_get/set_speed() to mxc_i2c.c" that after Heiko's ACK I have applied to u-boot-imx and then it is already merged into u-boot-arm. The patch you have sent now does not take care of your previous patch and does not apply anymore. Can you rebase your patch ? You can take u-boot-imx als reference, all imx related patches are already applied. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [email protected] ===================================================================== _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
