On 02/12/2011 19:01, Athanasios Silis wrote: > Hello Stefano and thank you for the quick reply. > To be honest, i'm not even sure what is the relocation you are talking > about... > What comes as a natural reply in my mind is: > this is an old board , too.
Very old. > once the code was ported it must have been working, no? With a specific U-boot version, yes. You can try with an older U-Boot version, checking out from GIT former releases, where the board was supported. > with or without CFI / ARM relocation. > so it feels odd that I doesn't start. With current code, it cannot start. > Besides, i'm not into any major project, so i'm not entirely sure i need > to have a latest version of u-boot. Try with a version <= 2009.08. > i'm fine by re-porting it. > only i know fairly little about booting systems. > is there a guide for porting u-boot? > or any sort of help I can use from somewhere? > somewhere to start from that is. Starting point can be at http://www.denx.de/wiki/DULG/Manual Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [email protected] ===================================================================== _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
