On 09/01/2012 21:22, Zach Sadecki wrote: > There are 2 locations in the power init code for the mx28 where IRQs are not > being cleared because incorrect methods to clear those bits were being used. > This was causing my board to get stuck waiting for POWER_CTRL_VDD5V_DROOP_IRQ > to clear. Using the correct method to clear the IRQs fixes it. > > Signed-off-by: Zach Sadecki <[email protected]> > Cc: Wolfgang Denk <[email protected]> > Cc: Stefano Babic <[email protected]> > ---
Applied to u-boot-imx, thanks. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [email protected] ===================================================================== _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
