On 13/04/2012 10:00, Dirk Behme wrote:
> Init the core regulator voltage to 1.2V. This is required for the correct
> functioning of the GPU and when the ARM LDO is set to 1.225V. This is a
> workaround to fix some memory clock jitter.
>
> Note: This should be but can't be done in the DCD. The bootloader
> prevents access to the ANATOP registers.
>
> Signed-off-by: Dirk Behme <dirk.be...@de.bosch.com>
> CC: Jason Chen <b02...@freescale.com>
> CC: Jason Liu <r64...@freescale.com>
> CC: Ranjani Vaidyanathan <ra5...@freescale.com>
> CC: Stefano Babic <sba...@denx.de>
> CC: Fabio Estevam <feste...@gmail.com>
> ---
Hi Dirk,
> +static void init_anatop_reg(void)
> +{
> + struct anatop_regs *anatop = (struct anatop_regs *)ANATOP_BASE_ADDR;
> + int reg = readl(&anatop->reg_core);
> +
> + /*
> + * Increase the VDDSOC to 1.2V
> + * Mask out the REG_CORE[22:18] bits (REG2_TRIG)
> + * and set them to 1.2V (0.7V + 0x14 * 0.025V)
> + */
> + reg = (reg & ~(0x1F << 18)) | (0x14 << 18);
Everything clear, but what do you mind to add an accessor to set this
voltage ? It is straightforward, and more boards could use it.
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
