Hello Tom, On 15.05.2012 08:24, Heiko Schocher wrote:
- change gpio pin settings:- gpio pin 6[13] (PLC reset) default value low - gpio pin 6[0] (TPM reset) default value low - 4 new GPIO pins pin i/o name - 3[9] input Board Type - 2[7] input HW-ID0 - 2[6] input HW-ID1 - 2[3] input HW-ID2 - read board type and hw id from gpio pins on the enbw_cmc board, and use board type for setting up different gpio pin settings. - do not pass "davinci_mmc.use_dma=0" to linux, as MMC now works with DMA. - update logbuf support: store post word in RTC scratch register - add support for configuring KSZ8864RMN switch through a config file on u-boot startup. For more infos see: doc/README.switch_config Signed-off-by: Heiko Schocher<[email protected]> Cc: Wolfgang Denk<[email protected]> Cc: Tom Rini<[email protected]> Cc: Christian Riesch<[email protected]> Cc: Sandeep Paulraj<[email protected]> --- changes for v2: - add comment from Tom Rini: remove ELDK-4.2 compiler warning: enbw_cmc.c: In function 'enbw_cmc_getvalue': enbw_cmc.c:447: warning: dereferencing type-punned pointer will break strict-aliasing rules $ ./tools/checkpatch.pl 0001-arm-davinci-update-for-enbw_cmc-board.patch total: 0 errors, 0 warnings, 498 lines checked NOTE: Ignored message types: COMPLEX_MACRO CONSIDER_KSTRTO MINMAX MULTISTATEMENT_MACRO_USE_DO_WHILE 0001-arm-davinci-update-for-enbw_cmc-board.patch has no obvious style problems and is ready for submission.
Tom? Are there more issues with this patch? bye, Heiko -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
