> -----Original Message----- > From: Holger Brunck [mailto:holger.bru...@keymile.com] > Sent: 05 July 2012 21:08 > To: u-boot@lists.denx.de > Cc: Holger Brunck; Valentin Longchamp; Gerlando Falauto; Prafulla > Wadaskar > Subject: [PATCH v4] arm/km: add kmnusa board support > > This board is similar to portl2, but it has the u-boot environment > in a SPI NOR flash and not in an i2c eeprom like portl2 have. > > Some other details: > - IVM EEPROM is at adress: pca9547:70:9 > - PCI is enabled > - PIGGY4 is connected via MV88E6352 simple switch. There is no phy > between the simple switch and the kirkwood. > > Signed-off-by: Holger Brunck <holger.bru...@keymile.com> > Signed-off-by: Valentin Longchamp <valentin.longch...@keymile.com> > cc: Gerlando Falauto <gerlando.fala...@keymile.com> > cc: Prafulla Wadaskar <prafu...@marvell.com> > --- > changes for v4: > - the wrong kwbimage_128M16_1.cfg file was picked up > this was already present in v2 due to the renaming issue > now fixed > changes for v3: > - rebase to current master > - use reset_phy funtion as on mgcoge3un > changes for v2: > - rename 128M16-1.cfg to kwbimage_128M16_1.cfg >
Applied this patch to u-boot-marvell.git master branch Regards... Prafulla . . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
