Hi Fabio,
On 10/25/2012 07:07 AM, Eric Nelson wrote:
Hi Fabio,
On 10/25/2012 06:28 AM, Fabio Estevam wrote:
Hi,
Using the latest u-boot-imx tree, I am getting the following on a mx6qsabrelite:
U-Boot 2012.10-09478-gab857f2 (Oct 25 2012 - 11:24:04)
<snip>
Hit any key to stop autoboot: 0
MX6QSABRELITE U-Boot> save
Unknown command 'save' - try 'help'
MX6QSABRELITE U-Boot>
Basically no commands are recognized.
Haven't started bisecting this yet, but just wanted to check if others
see the same issue.
You might want to check how you're programming this.
I saw this issue when U-Boot first went above 256k (the SPI-NOR
upgrade script only erased 0x40000 bytes).
I'll test later today.
Worked for me...
U-Boot 2012.10-01993-gab857f2 (Oct 25 2012 - 08:00:14)
CPU: Freescale i.MX6Q rev1.0 at 792 MHz
Reset cause: POR
Board: MX6Q-Sabre Lite
DRAM: 1 GiB
MMC: FSL_SDHC: 0, FSL_SDHC: 1
*** Warning - bad CRC, using default environment
auto-detected panel HDMI
enable_hdmi: setup HDMI monitor
Display: HDMI (1024x768)
In: serial
Out: serial
Err: serial
Net: FEC [PRIME]
Warning: FEC using MAC address from net device
Hit any key to stop autoboot: 0
MX6QSABRELITE U-Boot >
MX6QSABRELITE U-Boot > help
? - alias for 'help'
base - print or set address offset
bdinfo - print Board Info structure
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
