Hi Marek, On Thu, 25 Oct 2012 13:14:38 +0200, Marek Vasut <ma...@denx.de> wrote:
> Dear Fabio Estevam, > > CCing Albert. > > > Hi Stefano, > > > > On Thu, Oct 25, 2012 at 8:28 AM, Stefano Babic <sba...@denx.de> wrote: > > > Yes, I thins is due to the fact that size for the framebuffer is > > > allocated before relocation. This was also a reason for me to migrate to > > > CONFIG_VIDEO instead of CONFIG_LCD. > > > > mx53loco.h defines CONFIG_VIDEO, not CONFIG_LCD. > > > > I am suspecting alignment/gcc issues: with a gcc4.4 I can boot into a > > prompt, but after typing any command and then "enter" the board > > crashes and reboot. > > > > With gcc4.7, then board hangs after the total RAM is displayed. > > > > Regards, > > > > Fabio Estevam The board should normally not hang but throw a data abort. In any case, try to run the board under a HW debugger to find out which exception occurs. > Best regards, > Marek Vasut Amicalement, -- Albert. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot