From: Andy Tang <[email protected]>
When CONFIG_OPTEE is enabled on Layerscape boards, ft_add_optee_overlay()
applies the OP-TEE device-tree overlay to the kernel FDT and then calls
fdt_pack(). fdt_pack() shrinks the blob to its exact used size, which
discards the CONFIG_SYS_FDT_PAD free space that boot_relocate_fdt() had
reserved at the end of the FDT.
Later in the bootm flow fdt_initrd() inserts a memory reservation for the
ramdisk (fdt_add_mem_rsv) and writes the linux,initrd-start/-end
properties into /chosen. Without any spare space in the packed blob these
operations fail with:
fdt_initrd: FDT_ERR_NOSPACE
- must RESET the board to recover.
This only happens on OP-TEE builds because the overlay path is the only
caller of fdt_pack() in the FDT fixup sequence.
Remove the fdt_pack() call so that the free space reserved by
boot_relocate_fdt() is preserved and subsequent fixups have room to grow.
Signed-off-by: Andy Tang <[email protected]>
Signed-off-by: Chunguang.Li <[email protected]>
---
arch/arm/cpu/armv8/fsl-layerscape/dt_optee.c | 1 -
1 file changed, 1 deletion(-)
diff --git a/arch/arm/cpu/armv8/fsl-layerscape/dt_optee.c
b/arch/arm/cpu/armv8/fsl-layerscape/dt_optee.c
index 3345e6d61f1..e1d3dcda30a 100644
--- a/arch/arm/cpu/armv8/fsl-layerscape/dt_optee.c
+++ b/arch/arm/cpu/armv8/fsl-layerscape/dt_optee.c
@@ -30,7 +30,6 @@ int ft_add_optee_overlay(void *fdt, struct bd_info *bd)
ret = fdt_overlay_apply_verbose(fdt, (void
*)(rom_pointer[2] + SZ_1M));
if (ret == 0) {
debug("Overlay applied with success");
- fdt_pack(fdt);
}
} else {
printf("DTB overlay not present, exiting without
applying\n");
--
2.34.1
