Have you also set up the UCI.CONFIG file on the client end to match the new ud_databases reference?
There is a UCI.CONFIG editor supplied with the latest ODBC installs which should allow you to amend as needed. Robert -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Wang, Cody Sent: 01 Nov 2006 12:58 To: [email protected] Subject: [U2] ODBC: database does exist Hi all, I was trying to use VSG to connect the Unidata database. I was able to connect Unidata demo database, but once I change to our test database that I was not able to connect. I have change ud_database to point to our test database. The error message is database doesn't exist. Did I miss anything? Best regards, Cody Wang Datatel Programmer Analyst Ohio Dominican University 1-614-251-4799 ------- u2-users mailing list [email protected] To unsubscribe please visit http://listserver.u2ug.org/ This e-mail is for the use of the intended recipient(s) only. If you have received this e-mail in error, please notify the sender immediately and then delete it. If you are not the intended recipient, you must not use, disclose or distribute this e-mail without the author's prior permission. We have taken precautions to minimize the risk of transmitting software viruses, but we advise you to carry out your own virus checks on any attachment to this message. We cannot accept liability for any loss or damage caused by software viruses. ------- u2-users mailing list [email protected] To unsubscribe please visit http://listserver.u2ug.org/
