thanks....worked. SEEK filehandle,0,2
> -----Original Message----- > From: [email protected] [mailto:u2-users- > [email protected]] On Behalf Of David Ward > Sent: Wednesday, March 24, 2010 5:30 PM > To: 'U2 Users List' > Subject: Re: [U2] Writeseq - getting to the EOF > > Try "SEEK" > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of George > Gallen > Sent: Wednesday, March 24, 2010 4:26 PM > To: U2 Users List > Subject: [U2] Writeseq - getting to the EOF > > > ok. UV 10.0.2 > > Is there a quick way to get to the end of a file to start appending > after an > OPENSEQ Otherthan, a loop to READSEQ until it hits the EOF. > > Right now, that is not a problem, but this file could grow to some > considerable size, and > that loop might take a little bit to cycle through. > > I didn't see any options for the OPENSEQ to start at the EOF, and > didn't > find any commands > that would set the eof (other than WEOFSEQ which doesn't seem likely > to > help). > > Thanks > > > George Gallen > Senior Programmer/Analyst > Accounting/Data Division, EDI Administrator [email protected] > ph:856.848.9005 Ext 220 The Wyanoke Group http://www.wyanokegroup.com > > > > _______________________________________________ > U2-Users mailing list > [email protected] > http://listserver.u2ug.org/mailman/listinfo/u2-users > > _______________________________________________ > U2-Users mailing list > [email protected] > http://listserver.u2ug.org/mailman/listinfo/u2-users _______________________________________________ U2-Users mailing list [email protected] http://listserver.u2ug.org/mailman/listinfo/u2-users
